Aaru Device Report for HL-DT-ST DVDRAM GSA-T20N WP03

ATAPI device

Model HL-DT-ST DVDRAM GSA-T20N
Firmware revision WP03
  • ATA/ATAPI-4
  • ATA/ATAPI-5
  • ATA/ATAPI-6
  • ATA/ATAPI-7
Maximum ATA revision supported: ATA/ATAPI-7 T13 1532D revision 4a
  • ATAPI CD-ROM/DVD/etc device
  • Device shall set DRQ within 50 µs of receiving PACKET
  • ATAPI device uses 12 byte command packet
  • At minimum 120 ns. transfer cycle time per word in MDMA, 120 ns. recommended
  • At minimum 120 ns. transfer cycle time per word in PIO, without flow control
  • At minimum 120 ns. transfer cycle time per word in PIO, with IORDY flow control
  • 63488 bytes count limit for ATAPI
  • IORDY is supported and can be disabled
  • DMA is supported
  • PIO0
  • PIO1
  • MDMA0
  • MDMA1
  • MDMA2
  • UDMA0
  • UDMA1
  • UDMA2 (active)
  • NOP is supported
  • DEVICE RESET is supported
  • PACKET is supported
  • Power management is supported
  • Removable media feature set is supported
  • 28-bit LBA is supported
Vendor: HL-DT-ST (Hitachi-LG Data Storage, Inc.)
Product: DVDRAM GSA-T20N
Revision: WP03
  • Device is connected and supported.
  • CD-ROM/DVD/etc device
  • Device claims to comply with ANSI X3.408:2005 (SPC-3)
  • Device does not claim to comply with any SCSI ECMA standard
  • Device does not claim to comply with any SCSI ISO/IEC standard
  • Device is removable
  • Device supports setting Normal ACA
  • Device supports LUN hierarchical addressing
  • Device does not support asymmetrical access
  • Device supports only ST clocking
  • Device supports MODE SENSE (10)
  • Device supports MODE SENSE subpages
  • Drive will repeat read operations 99 times
  • Unknown recovery parameter 0x80
  • Drive will repeat write operations 3 times
  • Transfer rate: 24581 kbit/s
  • 8 heads
  • 0 cylinders
  • 16 sectors per track
  • 0 bytes per sector
  • Drive steps in 15000 μs
  • Target shall wait 0 seconds before attempting to access the medium after motor on is asserted
  • Target shall wait 0 seconds before releasing the motor on signal after becoming idle
  • Drive needs to do 1 step pulses per cylinder
  • Pin 34 is unconnected
  • Pin 4 is unconnected
  • Pin 2 is unconnected
  • Pin 1 is unconnected
  • Parameters can be saved
  • Write-cache is enabled
  • Drive does not distinguish between cached read data
  • Drive does not distinguish between cached write data
  • Pre-fetch will be done for READ commands of 2048 blocks or less
  • A maximum of 128 blocks will be pre-fetched
  • A maximum of 128 blocks will be pre-fetched even if it is commanded to pre-fetch more
  • Parameters can be saved
  • Drive will remain in track hold state 2 minutes after a seek or read
  • Each minute has 60 seconds
  • Each second has 75 frames
  • Drive will return from playback command immediately
  • Output port 0 has channels 0 at maximum volume
  • Output port 1 has channels 1 at maximum volume
  • Parameters can be saved
  • Standby timer Z is set to 32000 ms
  • Idle timer A is set to 10000 ms
  • Parameters can be saved
  • Drive will remain in same status 1 second after a seek, read or write operation
  • Drive can play audio
  • Drive can read sectors in Mode 2 Form 1 format
  • Drive can read sectors in Mode 2 Form 2 format
  • Drive supports multi-session discs and/or Photo-CD
  • Drive can read digital audio
  • Drive can continue from streaming loss
  • Drive supports C2 pointers
  • Drive can read Media Catalogue Number
  • Drive can read ISRC
  • Drive uses a tray
  • Drive can lock media
  • Drive is not locked, media can be ejected and inserted
  • Drive can eject media
  • Each channel can be muted independently
  • Each channel's volume can be controlled independently
  • Drive supports 256 volume levels
  • Drive has 2048 Kbyte of buffer
  • Drive's maximum reading speed is 4234 Kbyte/sec.
  • Drive's current reading speed is 4234 Kbyte/sec.
  • Drive can read and write CD-R
  • Drive supports reading CD-R packet media
  • Drive can read and write CD-RW
  • Drive can read DVD-ROM
  • Drive can read and write DVD-R
  • Drive can read and write DVD-RAM
  • Drive's current writing speed is 4234 Kbyte/sec. in CLV mode
  • Drive supports writing at 4234 Kbyte/sec. in CLV mode
  • Drive supports writing at 2822 Kbyte/sec. in CLV mode
  • Drive supports writing at 1764 Kbyte/sec. in CLV mode
  • Drive supports writing at 706 Kbyte/sec. in CLV mode
  • Drive supports test writing
  • Drive can read both sides of a disc
  • Drive can read raw R-W subchannel from the Lead-In
  • Drive supports DVD CSS and/or DVD CPPM
  • Drive supports buffer under-run free recording
  • Drive an read raw R-W subchannel from the Lead-In
  • Drive can continue from streaming loss
  • Drive can eject media
  • Drive can lock media
  • Drive can play audio
  • Drive can read and write CD-R
  • Drive can read and write CD-RW
  • Drive can read and write DVD-R
  • Drive can read and write DVD-RAM
  • Drive can read both sides of a disc
  • Drive can read digital audio
  • Drive can read DVD-ROM
  • Drive can read ISRC
  • Drive can read Media Catalogue Number
  • Drive can read sectors in Mode 2 Form 1 format
  • Drive can read sectors in Mode 2 Form 2 format
  • Drive has 2048 Kbyte of buffer
  • Drive is not locked, media can be ejected and inserted
  • Drive supports 256 volume levels
  • Drive supports buffer under-run free recording
  • Drive supports C2 pointers
  • Drive supports DVD CSS and/or DVD CPPM
  • Drive supports multi-session discs and/or Photo-CD
  • Drive supports reading CD-R packet media
  • Drive supports test writing
  • Drive supports writing at 1764 Kbyte/sec. in CLV mode
  • Drive supports writing at 2822 Kbyte/sec. in CLV mode
  • Drive supports writing at 4234 Kbyte/sec. in CLV mode
  • Drive supports writing at 706 Kbyte/sec. in CLV mode
  • Drive uses a tray
  • Drive's current reading speed is 4234 Kbyte/sec.
  • Drive's current writing speed is 4234 Kbyte/sec. in CLV mode
  • Drive's maximum reading speed is 4234 Kbyte/sec.
  • Each channel can be muted independently
  • Each channel's volume can be controlled independently
  • 2048 bytes per logical block
  • Drive can do a test writing in Session at Once Mode
  • Drive can do a test writing in Track at Once Mode
  • Drive can do a test writing with DVDs
  • Drive can eject media
  • Drive can format media into logical blocks
  • Drive can lock media
  • Drive can overwrite a SAO track with another in CD-RWs
  • Drive can overwrite a TAO track with another in CD-RWs
  • Drive can read and write DVD+R
  • Drive can read and write DVD+R DL
  • Drive can read and write DVD+RW
  • Drive can read CD-ROM
  • Drive can read DVD
  • Drive can return CD-Text from Lead-In
  • Drive can return Spare Area Information
  • Drive can write CD-RW
  • Drive can write CDs in Session at Once and in Raw Modes:
  • Drive can write CDs in Track at Once Mode:
  • Drive can write user provided data in the R-W subchannels in Session at Once Mode
  • Drive claims capability to read all CD formats according to OSTA Multi-Read Specification
  • Drive firmware is dated 12/11/2006 12:34:56 PM
  • Drive has 257 volume levels
  • Drive has an analogue audio output
  • Drive is able to mute channels separately
  • Drive is to report drive serial number
  • Drive shall report Read/Write Error Recovery mode page
  • Drive supports C2 Error Pointers
  • Drive supports DVD CPRM version 1
  • Drive supports DVD CSS/CPPM version 1
  • Drive supports Microcode Upgrade
  • Drive supports separate volume per channel
  • Drive supports set/release of PWP status
  • Drive supports the Informational Exceptions Control mode page 1Ch
  • Drive supports the SCAN command
  • Drive supports writing DVD-R, DVD-RW and DVD-R DL
  • Drive supports zero loss linking in Session at Once Mode
  • Drive supports zero loss linking in Track at Once Mode
  • Drive supports zero loss linking writing DVDs
  • Drive uses a tray
  • Drive uses ATAPI interface

Tested media information

Medium type code 41h
Logical sector size 2048 bytes
READ LONG sector size 2048 bytes
  • Drive recognizes this medium.
  • Device can use the READ CAPACITY (10) command with this medium
An unhandled error has occurred. Reload 🗙